In this video I demonstrate how fixing knots in wood v epoxy is an easy and quick process. Epoxy has actually a place in every woodshop and it can be a comfortable multitasker. The is crucial to include that v the certain epoxy that Im using, you should pour the in class no an ext than 1/4" deep when filling big voids. Wait because that each layer come cure before pouring the next one on top. This will avoid overheating and cracking of the epoxy. Feel cost-free to ask questions in the comments section and let me know what you think the the video.

If you choose this video please click right here to subscribe to mine channelYou can check out mine website because that more good stuff!




You are watching: Filling large voids in wood with epoxy

Full perform of tools that i use

Tools and also products provided in this video:

Total watercraft 2:1 Epoxy KitHazelnut PigmentDewalt 13” PlanerCard ScraperArmor device WorkbenchDSLR Cannon T6iExternal Lavalier Mic
*
*
*

First recognize the knot or void the you want to fill v the epoxy. Examine to watch if the void goes every the way through the board. Occasionally this could not be as noticeable as the void that Im filling in the video, you could have to check the area carefully. Making use of painters tape seal turn off one next of the void so that the epoxy will certainly not seep through and also leak once its poured. Don"t be shy through the tape!


*
*
*
*

There space many varieties of epoxy the end there bu Im utilizing Totalboat 2:1 proportion epoxy. I favor these dispensers due to the fact that the pumps do it so the it is same pumps because that epoxy resin come the hardner as soon as mixing it. So, for example, if girlfriend use 3 pumps of resin friend just include in three pumps that hardner rather of having to make sure you use the 2:1 ratio.

You can pick to leave her epoxy clean or girlfriend can add some tinted shade to it. I prefer this Hazelnut shade by Blackdiamond Pigment because that walnut since it blends in v the shade of the plank really well when the epoxy is cured. It only takes a small amount of colors to include a lot of shade to the epoxy therefore a little canister the this stuff will last you fairly a while.

Add the pigment to the epoxy and also hardner climate mix for three to 4 minutes or according to the direction of the epoxy that you space using.


*
*
*
*

Once your epoxy is mixed well, gradually pour the epoxy in the void area until it is slightly over filled. Wait several minutes come insure that the epoxy does not lower below the surface. Sometimes it can take a couple of minutes for the epoxy come seep into all the little cracks and voids inside the larger area which may require you to add much more so that the level remains slightly above the surface.


*
*
*
*

Once the epoxy is totally cured (time may vary) you deserve to remove the tape indigenous the various other side. Making use of a hand plane or map scraper remove the overfill epoxy so the it is level with your surface. If you have a thickness planer you can use a hand airplane or card scraper top top one side and also then operation it with the planner to flatten and smooth the various other side.




See more: What Your Smash Main Says About You R Main Says About You, What Your Main Says About You

*
*

As you deserve to see in the photos the Hazelnut shade blends perfectly v walnut and the void is totally filled. As soon as it concerns finish, just about any form of finish that you would commonly use in woodworking will additionally work ~ above the epoxy. Thats all and I expect you enjoyed!

For much more details you can watch the complete build video clip here:

If you want to see much more woodworking and DIY videos then you re welcome Subscribe to my channel